STATOR (HONDA)
Customer Service Hours:
Monday to Friday 8:30 AM TO 5:00 PM
Need help concerning the dealer section?
E.websupport@importationsthibault.com
Brand new aftermarket stator
- You must re-install your original connector and grommet (see picture).
- Once your connector and grommet is re-installed, our part becomes a plug-and-play unit, direct fit, and very easy to install.
- Higher grade of electric components.
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Specifications:
Dimensions :Interior diameter : 42 mm
Exterior diameter : 115 mm
Thickness : 23 mm
Length of wires stator to end : 650 mm
Other specifications :
Number of wires : 3
Number of pins : 3
Wire to wire resistance :
Alternator : Yellow Between Each Yellow = 0.3 ohms +/-20%
Alternator : Yellow To Ground = O. L. On Display
Warning:
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
