STATOR MITSUBA (HONDA)

Brand new aftermarket Stator

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• Highest grade of lamination materials
• Highest grade of copper windings, resistant to 200 degrees Celsius.
• Pick up pulsar coil included
• Connector included
• Rubber grommet included
• All products shipped are tested

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Specifications:

Dimensions :
Interior diameter : 29 mm
Exterior diameter : 83 mm
Thickness : 9 mm
Length of wires stator to grommet : 40 mm
Length of wires grommet to plug : 130 mm
Length of pickup coil's wire to grommet : 60 mm

Other specifications :
Number of wires : 2
Number of plugs : 2
Number of pins : 2

Wire to wire resistance :
Pickup : Blue/Yellow to Bracket = 120 ohms +-20%
Source : Black/Red to Ground = 715 ohms +-20%

Warning:

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.