Brand new aftermarket stator
Direct replacement to your original unit
Plug-and-play, direct fit, easy installation
Highest grade lamination materials
...Read More
Highest grade copper windings, resistant to 200 degrees Celsius.
Connector included
Rubber grommet included
All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause for repetitive electrical issues.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Specifications:
Dimensions :
Interior diameter : 42 mm
Exterior diameter : 104 mm
Thickness : 36 mm
Length of wires stator to grommet : 152 mm
Length of wires grommet to plug : 609 mm
Other specifications :
Number of wires : 3
Number of plugs : 1
Number of pins : 3
Wire to wire resistance :
Alternator : Between each Yellow = 0.4 ohms +-20%
Warning:
Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !
Fitment notice:
Please take note : There are 2 possible stators for Ducati Multistrada 2003-2006. This stator has an outside diameter of 104 mm, an inner diameter of 42 mm and a stack height of 36 mm.
We use cookies to improve your experience on our site, analyze traffic, and personalize content. By continuing to browse this site, you agree to the use of these cookies.