MOSFET REGULATOR

WHY USE SERIES ENHANCED TECHNOLOGY?

• Runs much cooler than the Shunt and MOSFET voltage regulator rectifier.
• Power only flows through the electrical components when the battery is charging.
• Allows the stator to have lower current flowing when not used, extending its lifetime.
• The regulator is easier to mount because it's smaller than the OEM one.


• With enhanced technology design

  This product is an advanced technology that lowers operating temperatures for extended longevity and better performance than the OEM part.

   

  THE SERIES VOLTAGE REGULATION TECHNOLOGY

  RMSTATOR SERIES voltage regulator brings better reliability and charging system performance. A SERIES regulator is a significant upgrade over typical shunt type voltage regulators. A shunt regulator controls battery voltage by grounding the stator coils to dissipate current as heat, rather than sending it on to the battery. SERIES regulators control battery voltage by intermittently disconnecting stator coils from the regulator electronics, limiting current flow through the unit and on to the battery completely. This results in lower regulator and stator temperatures, more accurate voltage regulation, and increased reliability of your charging system components.

  
  Brand new series voltage regulator rectifier

  THE ULTIMATE SOLUTION TO YOUR REGULATOR RECTIFIER PROBLEMS!
  It is time to update or replace your voltage regulator with the advanced series type. It runs cooler than all OEMs, Shunt or MOSFET, diode-style regulators. In addition, this rectifier has overheat protection, rather than burn up it will simply turn off for a while and cool off.

   

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • The quality exceeds the OEM equipment
  • Improved heat sink and charging capabilities
  • Higher grade of electric components
  • All shipped products are tested

   

  We even include the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.

  All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.

  Specifications:

  Dimensions:
  Width: 84 mm
  Length: 90 mm
  Height: 32 mm
  Fixation holes centre to centre: 69 mm

  Other specifications:
  Number of plugs: 2
  Number of pins: 5
  Minimum Charging Voltage: 14.5 V +- 0.5 V
  Maximum Charging Current: 50 A/500 W
  Open Circuit Voltage: <15 V
  Operation Temperature: -20° to 85°

  Warning:

  2006 2007 Can-Am Outlander 400 fitment requires a special installation. Refer to the "Installation" tab at the bottom of this page to see all the details

  Battery condition is important. No regulator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY!