2-POSITION IGNITION KEY SWITCH FOR CF-MOTO

Brand new aftermarket stator + CDI Box.

• All products shipped are tested.
• All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Stator:

• Direct replacement to your original unit.
• Plug-and-play, direct fit, easy installation.
• Highest grade of lamination materials.
• Highest grade of copper winding, resistant to 200 degrees Celsius.
• Pick up pulsar coil included.
• Connector included.
• Rubber grommet included.

CDI Box:

• Our PeakRPM CDI Box provides the optimal output for your ride.
• Enjoy fast and easy installation with our plug-and-play OEM design.
• OEM-grade electronic components and printed circuit boards for long-term reliability and performance.
• 90% of ignition issues are caused by a faulty stator. Fully test ignition components before buying.

Instructions:

Before installing your new Stator + CDI Box

• Check the AC output of the stator.
• Replace any burned or corroded connectors on the stator and regulator/rectifier.
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our parts may use a different wire colour code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator + CDI box are designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.

Warning:

Risk of electric shock. Disconnect the battery before servicing.
Ensure proper installation by a qualified technician to avoid malfunction.

Specifications

Stator:

Dimensions:
Interior diameter: 53 mm
Exterior diameter: 115 mm
Thickness: 16 mm
Length of wires stator to grommet: 160 mm
Length of wires grommet to plug: 460 mm
Length of pickup coil's wire to grommet: 110 mm
 

Other specifications:
Number of wires: 7
Number of plugs: 2
Number of pins: 7

Wire to wire resistance:
Alternator: White Between each White = 0.4 ohms +/-20%
Pickup: Green to Blue = 440 ohms +/-20%
Source: Red to Blue/White = 0.2 ohms +/-20%

CDI Box:

Dimensions:
Height: 27 mm
Length: 110 mm
Width: 78 mm
Distance between fixation holes: 126 mm

Other Specifications:
Number of plugs: 2
Number of pins: 14

Please note: The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model. Because of this, we recommend that you rule everything else out before replacing the CDI box.

Please note: There are two possible key switches for some models. This part will replace the 2-Position Key Switch. If you need a 3-Position Key Switch, see our RMS110-108410.