KIT STATOR + MITSUBISHI FLYWHEEL (APRILIA)
Customer Service Hours:
Monday to Friday 8:30 AM TO 5:00 PM
Need help concerning the dealer section?
E.websupport@importationsthibault.com
Brand New kit Flywheel + Generator Stator
Brand new aftermarket stator- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Connector included
- Rubber grommet included
- All shipped products are tested
We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.
Brand new Magneto Flywheel Rotor- All products are tested
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part
Specifications:
Generator Stator Dimensions :
Interior diameter : 42 mm
Exterior diameter : 105 mm
Thickness : 17 mm
Length of wires stator to grommet : 90 mm
Length of wires grommet to plug : 300 mm
Other specifications :
Number of wires : 3
Number of plugs : 1
Number of pins : 3
Wire to wire resistance :
Alternator : Between each White = 0.4 ohms +/-20%
Flywheel Dimensions:
Exterior Diameter: 115 mm
Interior Diameter: 108 mm
Interior Diameter Center Housing: 16 mm
Exterior Diameter Center Housing: 24 mm
Thickness (exterior): 30 mm
Thickness (interior): 33 mm
Warning:
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
Fitment notice:
Please Note : This kit will only work if your RSV4 has an engine number equal or lower than 3413. If your engine number is higher, you will need OEM 2D000044. This kit is working on rare occasion for Tuono V4.
