STATOR + FLYWHEEL + GASKET KIT (SUZUKI)

Brand new stator + flywheel + crankcase cover gasket kit.

• Direct replacement to your original unit.
• Plug-and-play, direct fit, easy installation.
• Highest grade of lamination materials.
• Highest grade of copper winding, resistant to 200 degrees Celsius.
• Connectors included.
• Rubber grommet included.
• All products shipped are tested.

All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

Instructions:

Before installing your new stator

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator rectifier.
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors.

Our stator may use a different wire colour code than your original. All of the wires are installed in the correct order; please do not change any of the wiring configurations. This stator is designed as a direct plug-in replacement and should be used as such. When bolting stator in, always use locking compound. If our stator includes a pick-up coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

Warning:

• Risk of electric shock. Disconnect the battery before servicing.
• Ensure proper installation by a qualified technician to avoid malfunction.

Before attempting to start your Suzuki adjusting the air gap is necessary. Rotate the flywheel so the raised node is lined up with the pick-up/pulser coil and adjust as close as possible but no less than 0.010".

Specifications:

Stator:

• Interior diameter: 38 mm
• Exterior diameter: 107 mm
• Thickness: 12 mm
• Length of wires stator to grommet: 160 mm
• Length of wires grommet to plug: 330 mm

Other specifications:
Number of wires: 3
Number of plugs: 1
Number of pins: 3

Wire to wire resistance:
Alternator: Yellow to Yellow = 0.5 ohms +/-20%

Flywheel:
Exterior Diameter: 118 mm
Interior Diameter: 108 mm
Interior Diameter Center Housing: 25 mm
Exterior Diameter Center Housing: 33 mm
Thickness (exterior): 34 mm
Thickness (interior): 27 mm

Warning:

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.